By: Jan Kdo
The computer needs addition of value for enhanced performance so that
accomplishment of our task becomes much more fast. Upgrading the RAM is not a
difficult task and this does not quite require any professional help. Upgrading
the computer memory is easy especially with most of the primary
memory used these days being DDR or DDR2, though there are
other options available too. If you learn how to install DDR or DDR2 modes then
it is helpful in learning upgrading the RAM and it is cost effective also. Also
both the processes give a better idea about the internal part of the computer.
You can have further than 2048 MB of memory which is quite
common nowadays.
Buying the new RAM
You can use the tools of antistatic wrist strap; screwdriver of Large
Phillips and with some medium standard of expertise you can easily complete the
task within one hour. If you already know the configuration of your computer
then you shall know how much RAM is present in your system. Otherwise you can
know it while the machine starts up as it will appear at the screen or even from
the BIOS. While you are purchasing the new RAM best quality and
compatibility, both are the important factors for your system and you can learn
about those through some simple research from the internet.
RAM slot and installation
After you are ready with the new RAM now you will have to install it to your
motherboard. You will have to cut off any electric connections to the system.
Locating the RAM slot on the motherboard is easy. It is always advisable to
study your motherboard manual provided by the manufacturer as it will be the
best guide to locate the slot. Usually you can put the new RAM in the empty
module but if the slots are occupied you will have to remove the old. You will
see that the slots have clips on both the ends which lock the
RAM. Such clips for locking include an aperture which is known
as groove. You shall slide the RAM unit amid the groove and the memory shall be
laid in the opening. But the lock clips will still remain open. Actually till
now the RAM is just positioned at the entrance and for the full insertion you
will have to tactfully apply some uniform force with the fingers at both sides.
The process of installation will be complete when you will not be able to see
the gold colored connectors at the bottom of the memory unit and the catch clip
will close by the side of the unit ends.
Concluding steps
Now without putting the cabinet back start the computer to see whether the
new added amount of memory is being displayed. If any error is found like
unrecognizing of the new RAM or locking of the system then
again disconnect to recheck the steps for installation of the memory. Start
again the machine to see the results. If the problem persist you must call for
some professional support.
